This jig is in conformity with JIS P 8147 'Paper and board- Determination of the static and kinetic coefficients of friction'.
This is a jig to make torsion tests by the load testing machine, instead of torque testing machine equipment. It is suitable for a small torsion angle.
The hand-operated roller which is prescribed in JIS Z 0237 testing method. It helps to let an examination board glue adhesive tape by predetermined force with 2kg in weight, a roller diameter of 83mm.
This jig is to fix a sample for an examination to stab. The sample is to be inserted from the opening on the to and all the circumference is to be fastened by turning the lever. As the upper jig, the pin chuck (GC-30) insetting needle with R0.5 of tip is used and by this the sample is to be stabbed.
It is a jig fixing a mounting board for tests to peel a device from it. There are a lot of mounting holes on the installation board, which can be set in three positions (horizontal, 45°vertical). It is combined with a X-Y table for alining it.
Heat is added to mounting boards, and a load evaluation can be performed. The photo shows the horizontal testing machine with the hot plate adequate for the heat less than 300℃.
Heat is added to electronic parts, and a load evaluation is performed. This plate can impose the heat up to 120℃. Several jigs prepared for the shape of parts can be used in exchange.
It is a jig to evaluate the torque characteristic of the torsion spring.
© 2018 Shraddha Impex. All Rights Reserved.
Developed by 
